Construction and scope
E-4 PORT is listed as a bias E-4 PORT range with 1 size and 1 recorded configuration.
Port · Bias
E-4 Port Tyre range for port equipment and terminal handling applications. Selection must be confirmed against load, speed, duty cycle and site conditions.
Last reviewed: October 2026

Series overview
This bias OTR tyre range is catalogued for port equipment and terminal handling cycles. The current range focuses on 18.00-25 port and terminal-equipment duty. Selection starts with the listed size and pattern, then requires a check of the actual machine and operating cycle.
The E-4 PORT designation identifies the port-oriented E-4 catalogue pattern. Compare it with the present tyre marking and equipment requirement. A matching code or size alone does not confirm fitment, load capacity or expected service life.
For this range, document paved terminal surfaces, turning frequency and concentrated operating loads. JABIL uses those inputs to confirm equipment type, wheel position, load, speed and shift pattern. Current tyre photos and a description of cuts, heat, wear or other failures help focus the review.
Technical data
TBC means the value is not present in the current source catalogue and must be verified before quotation. Load and pressure values are shown only at their stated speeds and must not be interchanged.
| Size | PR | Standard rim | OD mm | Width mm | Load 10 km/h kg | Load 50 km/h kg | Pressure 10 km/h kPa | 40HQ pcs |
|---|---|---|---|---|---|---|---|---|
| 18.00-25 | 40 | 13.00/2.5 | 1615 | 500 | 17000 | 9750 | 950 | 70 |
Catalogue evidence
These statements use only the published product dataset; final machine fitment still requires technical confirmation.
E-4 PORT is listed as a bias E-4 PORT range with 1 size and 1 recorded configuration.
The catalogue associates this range with Port equipment, Terminal handling. Its current site filters place it under port-industrial conditions.
18.00-25: 40 PR, rim 13.00/2.5, 1615 mm overall diameter, 500 mm section width.
Buyer questions
The catalogue associates this tyre with Port equipment and Terminal handling. Final suitability depends on the machine model, tyre position, load, speed, rim and operating conditions.
The current catalogue lists 18.00-25. Use the technical table to compare PR, standard rim, dimensions, load, pressure and container quantity where verified.
E-4 PORT identifies the port-oriented E-4 catalogue pattern. It is a starting point; it does not replace machine and duty-cycle verification.
Provide the tyre size, machine model, tyre position, load, maximum speed, daily hours, haul distance or cycle time, road condition, current failure mode, quantity and destination.
Continue with the port operating-condition guide →
Continue the comparison
Application check