Mining · Bias
E-3A Mining Tyre
E-3A Mining Tyre range for mining and earthmoving applications. Selection must be confirmed against load, speed, duty cycle and site conditions.
Series overview
E-3A Mining Tyre application and fit
This bias OTR tyre range is catalogued for mining and heavy earthmoving duty. The current range focuses on 14.00-25 and 14.00-24 mining and earthmoving duty. Selection starts with the listed size and pattern, then requires a check of the actual machine and operating cycle.
What the E-3A designation tells buyers
The E-3A designation identifies the earthmover or mining tread family recorded in the catalogue. Compare it with the present tyre marking and equipment requirement. A matching code or size alone does not confirm fitment, load capacity or expected service life.
Operating conditions to confirm
For this range, document haul-road surface, gradients, rock exposure and cycle heat. JABIL uses those inputs to review load, maximum speed, one-way haul distance, cycle time and common tyre failures. Current tyre photos and a description of cuts, heat, wear or other failures help focus the review.
Technical data
E-3A Mining Tyre available configurations
Blank values require technical confirmation. Load and pressure values are shown at their stated speeds and must not be interchanged.
| Size | PR | Standard rim | OD mm | Width mm | Load 10 km/h kg | Load 50 km/h kg | Pressure 10 km/h kPa | 40HQ pcs |
|---|---|---|---|---|---|---|---|---|
| 14.00-25 | 36 | 10 | 1370 | 375 | 5600 | — | 650 | 116 |
| 14.00-24 | 32 | 10 | 1320 | 325 | 10900 | 6150 | 1050 | 122 |
Buyer questions
Frequently asked questions about E-3A Mining Tyre
What equipment is the E-3A Mining Tyre intended for?
The catalogue associates this tyre with Mining and Earthmoving. Final suitability depends on the machine model, tyre position, load, speed, rim and operating conditions.
Which sizes are listed for the E-3A Mining Tyre?
The current catalogue lists 14.00-25, 14.00-24. Use the technical table to compare PR, standard rim, dimensions, load, pressure and container quantity where verified.
What does E-3A mean on this page?
E-3A identifies the earthmover or mining tread family recorded in the catalogue. It is a starting point; it does not replace machine and duty-cycle verification.
What information is needed to request a quotation?
Provide the tyre size, machine model, tyre position, load, maximum speed, daily hours, haul distance or cycle time, road condition, current failure mode, quantity and destination.
For a worked example of the data required before quotation, read the 29.5-25 mining tyre selection guide →
Continue the comparison
Related tyres and application records
Application check